![]() The splitters and mergers have a buffer of nine items that can be stored inside them, first-in, last-out.This allows you to expand a line of production buildings (a.k.a Manifold) later on. Plan ahead, get into a habit of adding a Conveyor Splitter before every input of production buildings.smelting ores, which are predominantly simple ratios of one to two, one to four or one to eight. ![]() This is a useful characteristic to apply efficient early game set-ups, e.g. So you can divide the input into two halves, or three thirds. Splitters will only split across the number of outputs you use.From the plan view, the input is always colored (default orange) while the outputs are always silver-colored. Its outputs are labelled 〕 arrow and the input is labelled ≡ as 3 smaller dots. It is easy to differentiate between the input and output slot by looking at the shape of the LED light at the belt connector.If any output is full, it will distribute the incoming items into the remaining outputs evenly.įunctions just like a Smart Splitter, but multiple filters (items) can be set for each output. The standard splitter plainly split items between its outputs in sequence. There are three types of splitters available, each with different sorting capabilities. If one output conveyor is backed up, the splitter will attempt to split the items among the remaining output belts, if all output conveyors are backed up, the splitter will stop splitting and build up its buffer of nine items and finally stopping the intake from the input conveyor.Īll types of splitters operate at a rate of 2 000/min, however, the fastest conveyor is 780/min. You can snap Splitters and Mergers onto either end of a Conveyor Lift.Ī splitter splits items from one input conveyor into one, two or three connected output conveyor(s), the input side must be connected to a belt for it to function. ![]() Splitters and Mergers cannot be built directly onto a building's belt connector (so attempting to extract items out of an overclocked Miner faster than the speed of a belt is not possible. When placing splitters on an existing belt, they do not snap to the foundation grid, even if the belt is on the ground level. This makes it easy to split items off of raised or stacked belts without first having to stack splitters up to the correct height. Splitters can be built directly onto straight sections of existing Conveyor Belt, even if the belt is elevated or sloped. You can stack the splitters and/or mergers on top of each other, each stacking offset by 2-meter height. It is advised to build other nearby belts before building the splitter/merger. For example, a splitter for Screw belt is likely to block the construction of Iron Plate belt. The Conveyor Splitter and Conveyor Merger have fairly large collision boxes which are likely to obstruct additional parallel belts.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |